×
Notice
The forum is in read only mode.
Forum
VoIP Gateways Support
GSM Gateway
WGW1002G as sip-client setup help nedded
×
Questions about VS-GW2120/GW1600/GW1202 and WGW1002G GSM Series VoIP Gateway
WGW1002G as sip-client setup help nedded
Less
More
Posts: 77
Karma: 5
Thank you received: 7
Less
More
Posts: 5
Thank you received: 0
9 years 4 months ago - 9 years 4 months ago #10086
by lexalex
I saw this manual before but it didn't help me
Just look at .../asterisk.tgz please
Last Edit: 9 years 4 months ago by
lexalex .
Less
More
Posts: 77
Karma: 5
Thank you received: 7
9 years 4 months ago #10087
by Michael.zou
Hi.
what do you mean "make it from the web-GUI without config-files editing"? For out geteway, you can edit your sip trunk and your routing rules in web-GUI, you can find them in the manual.
Less
More
Posts: 5
Thank you received: 0
9 years 4 months ago #10088
by lexalex
I mean: configure connection to external SIP without "ADVANCED/Asterisk File Editor" submenu
Or... I shuold edit line "register=>..." manually anyway. Right?
Less
More
Posts: 77
Karma: 5
Thank you received: 7
9 years 4 months ago #10089
by Michael.zou
you can set Registration in SIP - SIP Endpoints, if you want to use a sip phone or pbx to register to your gateway, you can set it as "Endpoint registers with this gateway", if you want your gateway register to anther pbx, you can set it as "This gateway registers with the endpoint", or if you want to config it as ip to ip, you can set it as none.
Less
More
Posts: 5
Thank you received: 0
9 years 4 months ago #10090
by lexalex
I made a SIP-connection as described in manual (using settings from provider (from asterisk.tgz)):
SIP Endpoints -> "Add New SIP Endpoint":
Name: testname
User Name: (mynum)
Password: (mypass)
Registration:This gateway registers with the endpoint
Hostname or IP Address: multifon.ru
Transport: TCP
NAT Traversal: Yes
Advanced:Registration Options
Authentication User: (mynum)
Register Extension: (mynum)
From User: (mynum)
From Domain: multifon.ru
Remote Secret: (mypass)
Port: 5060
Qualify: Yes
Qualify Frequency: 60
Outbound Proxy: sbc.megafon.ru
Call Settings
DTMF Settings
DTMF Mode: Inband Then: "Save" and "Apply"
I see "SIP Status"= "
Request Sent " in SYSTEM->Status->SIP_Information for "Endpoint Name"= (testname)
But I can make/accept calls with X-Lite softphone using the same settings!!
I got
register=>(mynum):(mypass):(mynum)@multifon.ru:5060/(mynum) in ADVANCED -> "Asterisk File Editor" -> sip_general.conf
but there should be
register=>(mynum)@multifon.ru:(mypass):(mynum)@sbc.megafon.ru:5060/(mynum) (in [general] section of sip.conf) according to exaple configiration
So,
Should I correct "
register=> " option manually?
Forum
VoIP Gateways Support
GSM Gateway
WGW1002G as sip-client setup help nedded
Time to create page: 0.047 seconds